ANNOUNCEMENTS

Shipping Charges
Please Read before ordering

If you are ordering less than 25 stickers or individual trading cards, please choose STANDARD shipping, your order will still be shipped Priority Mail.

If you are ordering just about anything else, please choose PRIORITY shipping.

If the shipping you are charged by my cart is more than a dollar over actual shipping, I refund excess shipping charges.

 ----------------------------

Ebay Scam Alert!
From July 16, 2007 until Aug 15, 2007, my Ebay account was hijacked by scammers. Just for the record: I'm in NC, I NEVER buy or sell electronics from eBay and I don't try to bypass Ebay's rules.

Live Long & prosper,
Brenda Germain
The REAL www.scifimosaic.com
Sci-Fi Mosaic

 ----------------------------

STAR TREK NEWS

Ultrarama
Star Trek Action Figure Display & Storage System

Customizing:  Painting 

Display tips for your Ultarama™

• The Ultarama™ is designed to display 3 ¾" - 6" figures that have pre-molded peg holes on the bottom of their feet.
  
  
• Your Star Trek Ultarama™ comes with two complete levels that you can use to display your collection. Each level has a total of 40 peg holes that have been pre-molded into the base of your unit. With the Ultarama's™ uniquely designed pegs that have been made to easily and snuggly fit into the pre-molded peg holes, you can display a total of 80 figures!
  
  
• When fully assembled in a semicircular shape, the Ultarama™ is 18 inches tall, 23 inches wide, and 10 inches deep.
  
  
• The Ultarama™ was designed to stack six stories high while resting on a table or shelf. We do not recommend directly attaching the Ultarama™ to a wall; rather, we recommend placing your Ultarama™ on a wall-mounted shelf.
  
  
• Your Ultarama™ is fully modular and can be configured and expanded in many ways. A cover, however, would not be able to grow and expand as you grow and expand your Ultarama™. Once you have created your perfect display, there are many local molders who make covers for autographed sports memorabilia that can easily and inexpensively make a cover for you.
  
  
• If your 6" pegs fit a little too tightly into my 4 ¾" figures, all you need is thirty seconds and a hand-held hair dryer. Hold the hair dryer approximately six inches from your figure's pre-molded peg holes. Blow hot air for thirty seconds on the figure's pre-molded peg holes and then peg your figure.
  
  
• If your figure does not have a pre-molded peg hole and you would like to use the pegs provided with your Ultarama™, then you need to drill a hole into the bottom of your figure's foot. We do not recommend doing this if you are concerned that a drilled hole might alter the condition, collectability or value of your figure. For current 3 ¾" figure releases, a 5/64" high speed steel drill bit should be suitable. For current 6" figure releases, a 1/8" high speed steel drill bit should be suitable.
  
  
• Expanding Your Ultarama™: You can stack your Ultarama™ up to six levels high when configured in a semicircular shape. When you display your units back-to-back using the pre-molded clips, however, you can stack them as high as you like.
  

Painting & Scenes | Display Tips